Radon Mitigation Systems in Delaware, OH

Radon Mitigation Systems in Delaware involves sub-slab depressurization with an inline radon fan, sealed slab penetrations, and an exterior discharge stack above the eave line, working on the slab-to-soil interface and any below-grade openings where soil gas enters the home. The service is the standard installation for any Columbus home testing above the EPA action level of 4.0 pCi/L on a 90-day or annual long-term average.

Delaware's pre-1950 downtown near Ohio Wesleyan sits on older limestone and block basements with masonry walls that admit soil gas through the wall itself as much as through a slab crack. The newer subdivisions ringing downtown are on poured basements with sumps, a more straightforward sub-slab suction candidate. Glacial till across Delaware County keeps both halves of the city inside EPA Zone 1, so the split is about mitigation routing, not about whether elevated readings occur. Delaware sits directly on the Olentangy River, with Delaware Dam and Delaware Lake just north of downtown holding back the river's upper watershed. Delaware sits on geology that drives elevated regional radon exposure across the Columbus metro, including Delaware County.

Delaware County's glacial till keeps the whole county in EPA Zone 1 regardless of foundation age, but the install itself differs: the historic limestone-and-block stock near downtown Delaware and Ohio Wesleyan needs a more deliberate seal at the foundation wall, while the US 23 growth corridor through Powell and Lewis Center offers ready sump pits for a single-point install.

Mitigation systems installed in Ohio must meet ANSI/AARST CCAH-2020-0523 for existing dwellings and be installed by a contractor licensed under ORC 3723.02 (Ohio Department of Health Radon Licensing Program). The Ohio Department of Health Radon Licensing Program oversees radon program compliance for Delaware, and Ohio licensure under ORC 3723.02 applies to any contractor performing mitigation work in the state.